Which switch would STP choose to become the root bridge in the selection process?()
A workgroup switch is configured with all ports assigned to VLAN 2. In addition,all ports are configured as full-duplex FastEthernet. What is the effect of adding switch ports to a new VLAN on this switch?()
You are configuring an 802.1Q trunk between a Layer 2 switch and a firewall. You read in the documentation that the best way to set up a trunk is to set the port as dynamic desirable. The trunk is not coming up. Which one of these options would be a valid explanation?()
Refer to the exhibit.The two connected ports on the switch are not turning orange or green. What would be the most effective steps to troubleshoot this physical layer problem?()
()is not a part of the main switch board.
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffiC.What is the effect of adding switch ports to a new VLAN on the switch?()
A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffic. What is the effect of adding switch ports to a new VLAN on the switch?()
A network administrator needs to force a high-performance switch that is located in the MDF to become the root bridge for a redundant path switched network. What can be done to ensure that this switch assumes the role as root bridge?()
What is the name of the VTP mode of operation that enables a switch to forward only VTP advertisements while still permitting the editing of local VLAN information?()
The network is displayed in the diagram below: You use the following information for switch SWA: Port Mode Encapsulation Status Native VLAN fa0/1 desirable n-802.1q trunking 5 Port VLANs is allowed on trunk fa0/ 1 1-100, 102-1005 Port VLANs is owned and active in management domain fa0/1 1-6. 8-100, 102-115, 197-999, 1002-1005 Port VLANs in spanning tree forwarding state and not pruned fa0/1 1-6, 8-100, 102-105, 108-999, 1002-1005 SW users in VLAN 107 complain that they are unable to gain access to the resources through theSW1 router. What is the cause of this problem?()