Switch SW1 has been configured with Private VLANs. With that type of PVLAN port should thedefault gateway be configured?()
Refer to the output shown on switch SW1 below: Warning: Spantree port fast start should only be enabled on ports connected to a single host.Connecting hubs, concentrators, switches, bridges, etc. to a fast start port can cause temporaryspanning tree loops. Use with caution. Spantree ports 4/1-24 fast start enabled. What command could you enter to reproduce this output?
Which two networks does the SW1 device have feasible successors for?()
Exhibit SW1#show spanning-tree vlan 200 VLAN200 Spanning tree enabled protocol iee eRoot ID Priority 32968 Address 000c.ce29.ef00 Cost 19 Port 2 (FastEthernet0/2) Hello time 10 Sec Max Age 20 sec Forward Delay 30 sec Bridge ID Priority 32968 (priority 32768 sys-id-ext 200) Address 000c.ce2a.4180 Hello Time 2 sec Max Age 20 Sec Forward Delay 15 sec Interface Role Sts Cost PrioNbr Type Fa0/2 Root FWD 19 128.2 P2p Fa0/3 Altn BLK 19 128.3 P2p Based on the show spanning-tree vlan 200 output shown in the exhibit, which two statementsabout the STP process for VLAN 200 are true?()
Refer to the exhibit. SW1 and SW2 have default configurations. What will happen if host 1 sends a broadcast?()
PSU电源模块转换开关SW1在“TCMS”档表示由微机自动控制()。
C&C08交换机AM模块MPU板的开关SW1-7,SW1-8都打在ON上,表示AM和SM之间的通信带宽是()。
200H设备在机控优先情况下,CRH2车VC单元BUF板拨码开关SW1~SW3的设置为()。
CTCS2-200H型列控车载设备在BUF板卡上设有拨码开关,SW1拨码开关是设定()。
HTK-391型红外线轴温探测系统探测站的站号是17(十进制),那么在主机板上SW1应拨成()(十六进制)。