Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which routes would be redistributed into OSPF area 1?()
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result?()
Configuration management system can be used in defining approval levels for authorizing changes and providing a method to validate approved changes.()is not a project configuration management tool.
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.0 0.0.0.255 any What is the effect of this access list configuration?()
Which two configuration elements are required for a route-based VPN?()
Which configuration command configures IS-IS to support MPLS Traffic Engineering?()
Part of the configuration files for routers testking1 and testking2 are displayed below: If you were to enter the "show interface serial 0" command on router testking1,which of the following will be displayed?()
You just purchased a refurbished router that contains a configuration from a previous deployment. What should you do, before entering a new configuration into the router?()
What should you set the Client Configuration to when configuring the ODBC Data Source for the Database Subsystem?()
Assume the default-policy has not been configured.Given the configuration shown in the exhibit, which two statements about traffic from host_a inthe HR zone to host_b in the trust zone are true?() [edit security policies from-zone HR to-zone trust] user@host# show policy one { match { source-address any; destination-address any; application [ junos-http junos-ftp ]; } then { permit; } } policy two { match { source-address host_a; destination-address host_b; application [ junos-http junos-smtp ]; } then { deny; } }